AEG KVH 32 Guía de usuario descargar pdf (Pagina 48)

KVH recognizes that some customers may not want to take

advantage of this convenient feature. In this case, it is possible to

disable Sleep Mode using a simple software command as follows:

1. Connect a laptop computer to the system using the

maintenance port and open the KVH Flash Update

Wizard or HyperTerminal, as described in

Section 2.5.1, “Installing Your Selected Satellites” on

page 2-16.

2. Turn on the antenna. When the limit switch test is

complete:

a. Type

HALT then press Enter.

b. Type

DEBUGON then press Enter.

c. Type

SLEEPOFF then press Enter.

3. Turn the antenna off by pressing its power button.

4. Wait 30 seconds then press the antenna’s power

button to turn the antenna back on. Sleep Mode is

now disabled. To reactivate Sleep Mode, follow this

same process, typing

SLEEPON instead of

SLEEPOFF during Step c.

Using your TracVision R5 While Moving

(TracVision R5 Only)

The antenna unit uses conical scanning to maintain peak signal

strength to the receiver and to update the satellite’s position.

When conical scan tracking is active, the antenna moves

continually with a circular motion to sweep across the satellite’s

peak signal. The signal strength is then fed back to the control

circuits to keep coming back to the direction of the strongest

signal.

3-9

Using Your TracVision R5/R4

54-0157 Rev. J

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 60 61

Sin comentarios

AEG KVH 32 Guía de usuario Pagina 48