AEG KVH 32 Guía de usuario descargar pdf (Pagina 22)

2-11

Installation

54-0157 Rev. J

2.3.3 Connecting the Receiver Ground Wire

A grounding wire (Cable #32-0583-50) has been provided to

connect your receiver to a suitable ground and protect the

system. Attach the grounding wire to any suitable screw on the

rear panel of the receiver with a good contact with the receiver

chassis. The other end should be connected to a suitable ground.

2.3.4 Installing the Switchplate

After completing the switchplate wiring process, you must install

the switchplate itself. This process, detailed in the following

steps, is illustrated in Figure 2-13.

Figure 2-13

Mounting the Switchplate

1. Fit the switchplate assembly and support frame

into the panel cutout made in Step 2 of Section 2.3,

“Connecting System Components” on page 2-8 and

flush to the mounting surface.

2. Drill out four

⁄32" (4 mm) holes in the countersunk

settings in the switchplate support frame.

3. Drill four

⁄32" (2.5 mm) holes in the mounting

surface using the countersunk holes in the support

frame as the template. Secure the support frame

and switchplate assembly to the mounting surface

using four #6 self-cutting screws.

Before securing the switchplate to

the mounting surface, be sure to

strain-relieve the wires connecting

to the switchplate connectors.

Several tie-wraps have been

provided to aid in strain-relieving

the wires.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 60 61

Sin comentarios

AEG KVH 32 Guía de usuario Pagina 22