Entering User-defined Satellite Data
Once the link between the PC and the TracVision R5/R4 is
established as described in Section 2.5.1, “Installing your Selected
Satellites” on page 2-16, follow the steps below to begin entering
the data for your user-defined satellite.
1. Type
HALT then press Enter.
2. Type the following command (see the Key below)
then press Enter.
SATCONFIG,USERX,YYY,Z,D,L
Key: X = 1 or 2 (This represents the first or second user-
defined satellite. Your TracVision system allows
up to two user-defined satellites.)
YYY = longitude (0-180)
Z = E (East) or W (West)
D = decoding type (0 = test, 1 = DSS-A,
2 = DSS-B, 3 = DVB)
L = LNB polarization (C = circular, L = linear)
The main board has now been configured to recognize the user-
defined satellite. Next, the RF board must be configured.
2-19
Installation
54-0157 Rev. J
Comentarios a estos manuales