AEG FM4300GAN Manual de usuario descargar pdf (Pagina 9)

Mounting:

When mounting several hobs together you must use a reinforcement beam

between each hob as well as the silicone supplied with the hobs. (see fig.)

1. Cut a hole of the calculated size in the table top

2. Place the individual hobs upside down on a mat. Take care that the top side is

not scratched.

3. Mount the clamping fittings in the holes in the side of the base panels (see

fig.)

4. Place the first hob in the hole.

5. Apply silicone to the two corners joining the next hob (see fig.)

Use only the silicone supplied with the hobs as this is intended to tolerate the

high temperatures of the appliance.

6. Push a reinforcement beam up against the hob. Apply silicone on the rein-

forcement beam (see fig.)

7. Tighten the clamping fittings to the table top using a screwdriver.

8. Repeat the process for the other hobs.

Silicone

Before Use

Protect the ceramic hob

Clean the burners

Before using the product for the first

time, clean off any factory residues

such as dust or dirt. Give the ceram-

ic hob a protective coating before

using it. This will make it easier to

clean the hob and will prevent spills

etc. burning on too hard.

This is what you do:

1. Remove the pan support(s), burn-

er ring and burner cover.

2. Sprinkle a few drops of a ceramic

cleaning agent onto a piece of

kitchen paper and rub into the

whole surface.

3. Polish the hob with a clean cloth

until dry.

Wash the pan stands, burner covers

and burner rings in hot water and

washing-up liquid.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

AEG FM4300GAN Manual de usuario Pagina 9