AEG FM4300GAN Manual de usuario descargar pdf (Pagina 11)

22

1. Cut a hole in the worktop of the

given dimensions, see “Technical

data”, “installation dimensions”.

2. Place the hob upside down on a

soft underlay. Make sure not to

scratch the top surface.

3. Mount the fixings in the holes in

the sides of the base box. (See

fig.).

4. Insert the hob in the hole and

tighten the fixings to the worktop

with a Phillips screwdriver.

However, to ensure accessi-

bility to the gas connection

there should generally be at

least 50 mm between the

rear of the hole for the gas

hob and the wall behind it.

Mounted clamping fittings

11

Burners

Make quite sure the burner

ring and burner cap are posi-

tioned correctly over the

burner top.

For correct combustion the burner

rings and burner cap must be posi-

tioned correctly over the burner

body. If the burner rings and caps

are off-centre, the gas flame will

burn incorrectly and the burner caps

may be ruined in a short space of

time.

Control knobs

The control knobs have the follow-

ing settings:

Off:

O

Minimum:

f

Maximum:

e

1. Press down the control knob for

the desired burner

2. Hold the knob down while turn-

ing it to the left to

e

.

3. Keep the knob pressed down for

4-5 seconds. Then release it and

turn the knob to the required set-

ting.

Burner ring Burner cap

Burner body Safety device

Right

Wrong

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios