AEG KFA58SIO Manual de usuario descargar pdf (Pagina 14)

If you tried the above solutions and can-

not repair the problem, speak to your

dealer or the customer service. Give the

data from the rating plate, three digit

letter code for the glass ceramic (it is in

the corner of the glass surface) and an

error message that comes on.

Make sure, you operated the appliance

correctly. If not the servicing by a cus-

tomer service technician or dealer will

not be free of charge, also during the

warranty period. The instructions about

the customer service and conditions of

guarantee are in the guarantee booklet.

8. INSTALLATION

WARNING!

Refer to the Safety chapters.

Before the installation

Before the installation of the appliance,

record the information below from the

rating plate. The rating plate is on the

bottom of the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

WARNING!

During installation in combusti-

ble matter, NIN SEV 1000 and

fire protection guidelines and

regulations of the Association of

Cantonal Fire Insurance shall be

strictly adhered to.

8.1 Built-in appliances

• Only use the built-in appliances after

you assemble the appliance into cor-

rect built-in units and work surfaces

that align to the standards.

8.2 Connection cable

• The appliance is supplied with the

connection cable.

• Replace the damaged mains cable

with a special cable (type H05VV-F or

higher). Speak to your local Service

Centre.

8.3 Electrical connection

• Install the appliance with a socket sup-

ply line. If there is no socket supply

line, the fixed home electrical system

must include an isolating device with

at least a 3 mm-contact separation to

enable a simultaneous and all-pole cut

off from the mains (according to NIN

SEV 1000).

8.4 To attach the seal to the

rabbet

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the

upper surface of the rabbet along the

edges of the cut out section.

• Cut the seal stripe into four pieces in

relation to the length of the edges of

the rabbet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut in-

to mitres. Do not bond the ends over

one another.

• Bond the seal stripe flush into the cor-

ner of the rabbet. Make sure that no

silicon compound can get below the

glass ceramic when grouting.

• Do not extend the tapes.

14

www.aeg.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios