AEG HG975550VB Manual de usuario descargar pdf (Pagina 9)

Supply pipe sizing

The total hourly gas consumption for the

appliance is shown on the data label.

The required supply pressure (i.e. at inlet

to appliance regulator) for each gas type

is shown on the data label, refer to the

Technical data chapter. Use this

information in conjunction with the

length of run, number of elbows, tees

and bends, the available service pressure

and the supply requirements of other

installed appliances to determine a

suitable pipe size. For assistance in this

matter refer to the appropriate section of

AS/NZS 5601.1 or AS/NZS 5601.2.

An AGA certified class B or D flexible

connection can be used to connect the

cooktop in accordance with AS/NZS

5601.1, in particular section 5.9 and

clause 6.10.1.8, or AS/NZS 5601.2, in

particular section 2.11. Where a hose

assembly is used and the cooktop is in

the installed position, the hose assembly

shall be suitable for connection to a fixed

consumer piping outlet located at a

point 800 – 850mm above the floor and

in the region outside the width of the

appliance to a distance of 250mm. The

point of connection to consumer piping

must be accessible with appliance

installed.

Be careful the hose does not come in

touch with mobile parts or is not

squeezed. Also be careful when the hob

is put together with an oven. Ensure that

the hose assembly is restrained from

accidental contact with the flue outlet of

an underbench oven or any other hot

surface of an adjacent appliance.

Regulator

The regulator must be positioned that

the pressure test nipple is accessible

when the appliance is installed. Connect

the gas supply to the ½ B.S.P. internal

thread inlet of the regulator. Refer to

worktop cut out for connection point

position.

A

B

A.

Outlet

B. Inlet

Assembly of regulator

To assembly the regulator to the

cooktop use the elbow and washer

supplied with the appliance.

The ½" parallel thread connects to the

end of shaft with nut. The washer is

placed between the end of shaft and the

elbow.

The ½" tapered thread connects to the

outlet of the regulator, and is sealed on

the thread. Use thread sealing tape or

thread sealing compound.

The inlet of the regulator is a ½” parallel

thread and is connected to consumer

piping or hose assembly.

The regulators are

configured for use with

Natural Gas. It is not

required to adjust the

regulator to obtain correct

outlet pressure setting.

When the inlet and outlet is

orientated correctly the

arrow on the base of the

regulator indicates the

direction of gas flow.

Checking the gas supply

It takes additional time to

light the gas for the first

time. Air is purged from the

pipes.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios