AEG KVH 32 Guía de instalación descargar pdf (Pagina 36)

Wire the IP AutoSwitch

The wiring of the IP AutoSwitch depends on the

specific configuration. Refer to the wiring

diagrams provided in “Wire the Receivers” on

page 13, while following the general wiring steps

below:

a. Disconnect the RF input cable from the

receiver and connect it to the “RF In” jack on

the IP AutoSwitch. Then tighten to 15 in.-lbs

of torque.

b. Connect the supplied 2 ft (60 cm) RF cable

from the “To Receiver” port on the IP

AutoSwitch to the receiver’s satellite input

and tighten to 15 in.-lbs of torque.

c. Using the supplied Ethernet cable, connect

the “Network” port of the IP AutoSwitch to

the onboard network. If a network is not

available, install a router as shown in

Figure 60.

d. If not already connected, connect the TV-Hub

to the onboard network (see Figure 60).

e. Using the supplied Velcro strip, secure the

IP AutoSwitch to the mounting surface.

Connect up to 3 IP AutoSwitches

4 3 2 18 7 6 5

POE

48V

Switch

* Network Connections

Connect the TV-Hub and IP AutoSwitch(es) to your

onboard network. If you do not have a network, install

a router or router and switch as shown below.

Connect up to 7 IP AutoSwitches

Router

12VDC

POWER

ResetEthernet Internet4321

AC Power

Connect up to 2 IP AutoSwitches

Router

12VDC

POWER

ResetEthernet Internet4321

To TV-Hub

AC Power

TV-Hub

Receiver

AC Power

Satellite In

IP AutoSwitch

To Receiver

RF In

Network

** Varies depending on your system configuration

To Network*

RF Input**

Figure 60: IP AutoSwitch Connections

Continued Installing an IP AutoSwitch

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

Comentarios a estos manuales

Sin comentarios

AEG KVH 32 Guía de instalación Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Placas AEG KVH 32