AEG HG755820UM Manual de usuario descargar pdf (Pagina 13)

agree with the voltage and the power

of the local power supply.

• This appliance is supplied with a

mains cable and a plug.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that

the ground connection agrees with

the standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

Make sure that you connect

the blue neutral cable to the

terminal with a letter "N" on

it. Connect the brown (or

black) phase cable to the

terminal which has a letter

"L". Keep the phase cable

connected at all times.

8.4 Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H05V2V2-FT180.

Make sure that the cable section is

applicable to the voltage and the

working temperature. The yellow / green

earth wire must be approximately 2 cm

longer than the brown (or black) phase

wire.

8.5 Building In

min.

55 mm

min.

650 mm

560 mm

490 mm

min.

150 mm

30 mm

10 mm

86 mm

86 mm

A

3 mm

CAUTION!

Install the appliance only on

a worktop with flat surface.

8.6 Possibilities for insertion

The panel installed below the hob must

be easy to remove and let an easy access

in case a technical assistance

intervention is necessary.

The burner flame may be

extinguished by an air flow,

if the removable panel is not

installed. The air flow may

occur when you open or

close the cabinet door or

drawer.

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios