AEG HG755820UM Manual de usuario descargar pdf (Pagina 12)

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Model .......................................

PNC .........................................

Serial number ...........................

8.2 Gas Connection

WARNING!

The following instructions

about installation,

connection and

maintenance must be

carried out by qualified

personnel in compliance

with standards and local

regulations in force.

It is necessary that the connection to the

gas mains are carried out by means of an

AGB tap. Choose fixed connections or

use a flexible pipe in AGB (stainless

steel) in compliance with the regulation

in force (NBN D 51.003). If you use

flexible metallic pipes, be careful they do

not come in touch with mobile parts or

they are not squeezed. Also be careful

when the hob is put together with an

oven.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values. The

adjustable connection is

fixed to the comprehensive

ramp by means of a

threaded nut G 1/2". All the

components shown in the

figure have already been

assembled in the factory.

The appliance, before

leaving the factory, has been

tested in order to give you

the best results.

A B C

A) End of shaft with nut

B) Washer

C) Elbow (if needed)

Liquid gas

Use the rubber pipe holder for liquid

gas. Always engage the gasket. Then

continue with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its

full length;

• the material is not hardened, but

shows its correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is

complete, make sure that

the seal of each pipe fitting

is correct. Use a soapy

solution, not a flame!

8.3 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate

www.aeg.com

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios