AEG 600 M Manual de usuario descargar pdf (Pagina 12)

12

For the Fitter

Fig. 2 Fixing the capillary-tube thermostat

Fig. 3 Push on adjuster knob

2.3 Installation and Electrical Connection

●

The installation and Electrical Connection may

only be carried out by a competent electrician.

●

Turn off all electricity supplies to the heater.

To do this, interrupt the electricity supply to

both the charge and the discharge circuits.

Caution: Even if the main circuit breakers

are switched off, some terminals

carrying on-peak current,

especially terminals A1/Z1 and

A2/Z2 can still be live.

●

Also read the Instruction Leaflet supplied with

the storage heater.

●

Unscrew and remove the top screw from the

left-hand side panel.

●

Remove the right-hand side panel and cover

panel of the storage heater. Break out the

knock-outs in the side panel.

●

Carefully remove the plastic fascia plate from

the inside of the heater front panel using a

screwdriver to gently push out the holding tabs

(Fig. 1).

Attention: The angle of the screwdriver should

be set as close as possible to the

inside of the front panel (oblique

angle prevents breakage of the fascia

plate and/or chipping of the paint-

work).

●

Fix the capillary-tube thermostat to the fixing

plate through the opening in the front panel

using the M4x6 fixing screws supplied (Fig. 2).

●

Push the adjuster knob on to the spindle of the

capillary thermostat (Fig. 3).

Make sure that the wires are not touching

any hot surfaces, that they are neither

damaged nor squeezed when replacing the

side panel and that no internal wiring is

touchable from the outside through the

air-slits.

Fig. 1 Plastic fascia plate with holding tab

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Comentarios a estos manuales

Sin comentarios