AEG KFA69DO Manual de usuario descargar pdf (Pagina 14)

at least a 3 mm-contact separation to

enable a simultaneous and all-pole cut

off from the mains (according to NIN

SEV 1000).

8.4 To attach the seal to the

rabbet

• Clean the rabbet in the work surface.

• Bond the seal stripe supplied on the

upper surface of the rabbet along the

edges of the cut out section.

• Cut the seal stripe into four pieces in

relation to the length of the edges of

the rabbet.

• For the four corners of the rabbet the

ends of the seal stripes must be cut in-

to mitres. Do not bond the ends over

one another.

• Bond the seal stripe flush into the cor-

ner of the rabbet. Make sure that no

silicon compound can get below the

glass ceramic when grouting.

• Do not extend the tapes.

8.5 Assembly

min.

50mm

min.

500mm

704

514

min.55mm

490

680

R10mm

R5mm

12mm

7mm

min.

12 mm

min.

2 mm

min.

38 mm

min.

2 mm

If you use a protection box (an additional

accessory

), the protective floor directly

below the appliance is not necessary.

You can not use the protection box if

you install the appliance above an oven.

The protection box accessory may not be available in some countries. Please contact

your local supplier.

www.aeg.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

AEG KFA69DO Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Placas AEG KFA69DO