AEG KFA58SM Manual de usuario descargar pdf (Pagina 11)

Problem Possible cause Remedy

Activate the hob again and

set the heat setting in less

than 10 seconds.

You touched 2 or more sen-

sor fields at the same time.

Touch only one sensor field.

There is water or fat stains

on the control panel.

Clean the control panel.

An acoustic signal sounds

and the hob deactivates.

An acoustic signal sounds

when the hob is deactivated.

You put something on one

or more sensor fields.

Remove the object from the

sensor fields.

The hob deactivates. You put something on the

sensor field .

Remove the object from the

sensor field.

Residual heat indicator does

not come on.

The zone is not hot because

it operated only for a short

time.

If the zone operated suffi-

ciently long to be hot, speak

to an Authorised Service

Centre.

The sensor fields become

hot.

The cookware is too large or

you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

comes on.

Automatic Switch Off oper-

ates.

Deactivate the hob and acti-

vate it again.

comes on.

The Child Safety Device

function operates.

Refer to "Daily use" chapter.

and a number come on.

There is an error in the hob. Disconnect the hob from the

electrical supply for some

time. Disconnect the fuse

from the electrical system of

the house. Connect it again.

If comes on again, speak

to an Authorised Service

Centre.

E6 comes on. The second phase of the

power supply is missing.

Check if the hob is correctly

connected to the electrical

supply. Remove the fuse,

wait one minute, and insert

the fuse again.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also

three digit letter code for the glass

ceramic (it is in the corner of the glass

surface) and an error message that

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios