AEG 11126GR-MN Manual de usuario descargar pdf (Pagina 21)

the above steps in the opposite

sequence.

The screen-printing zone must face the

inner side of the door. Make sure that

after the installation the surface of the

glass panel frame on the screen-printing

zones is not rough when you touch it.

Make sure that you install the internal

glass panel in the seats correctly.

12.5 Replacing the lamp

Put a cloth on the bottom of the interior

of the appliance. It prevents damage to

the lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

The back lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

13. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

13.1 What to do if...

Problem Possible cause Remedy

There is no spark when you

try to activate the spark gen-

erator.

The hob is not connected to

an electrical supply or it is

connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the connec-

tion diagram.

There is no spark when you

try to activate the spark gen-

erator.

The fuse is blown. Make sure that the fuse is

the cause of the malfunction.

If the fuse is blown again

and again, contact a quali-

fied electrician.

There is no spark when you

try to activate the spark gen-

erator.

Burner cap and crown are

placed incorrectly.

Place the burner cap and

crown correctly.

ENGLISH 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Comentarios a estos manuales

Sin comentarios