AEG KFA58HPM Manual de usuario descargar pdf (Pagina 8)

7.1 What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the hob.

The fuse is blown. Make sure that the fuse is

the cause of the malfunction.

If the fuse is blown again

and again, contact a quali-

fied electrician.

Residual heat indicator does

not come on.

The zone is not hot because

it operated only for a short

time.

If the zone operated suffi-

ciently long to be hot, speak

to an Authorised Service

Centre.

There is a dark area on

the multiple zone.

It is normal that there is a

dark area on the multiple

zone.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Make sure,

you operated the hob correctly. If not the

servicing by a service technician or

dealer will not be free of charge, also

during the warranty period. The

instructions about the Service Centre and

conditions of guarantee are in the

guarantee booklet.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Hob and oven connection

type

This appliance has a blue 1x14 pole and

red 1x14 pole connector and can be

connected to an oven with a blue 1x14

pole and red 1x14 pole connector.

8.2 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.3 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

During installation in combustible

matter, NIN SEV 1000 and fire protection

guidelines and regulations of the

Association of Cantonal Fire Insurance

shall be strictly adhered to.

8.4 Electrical connection

Install the hob with a socket supply line.

If there is no socket supply line, the fixed

home electrical system must include an

isolating device with at least a 3 mm-

contact separation to enable a

simultaneous and all-pole cut off from

the mains (according to NIN SEV 1000).

www.aeg.com

8

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios