AEG HK312000H Manual de usuario descargar pdf (Pagina 18)

• Install anti-shock protection, for example install the drawers only with a protective panel

directly below the appliance!

• Prevent damage of the cut surfaces of the worktop against moisture with a correct seal-

ant!

• Seal the appliance to the worktop with no space left with a correct sealant!

• Prevent damage of the bottom of the appliance from steam and moisture, e.g. from a

dishwasher or oven!

• Do not install the appliance adjacent to doors and below windows! If not, hot cookware

can be hit off the hob when you open doors or windows.

• Disconnect the appliance from the electrical supply, before you do maintenance

work or clean.

WARNING!

Risk of injury from electrical current. Carefully obey the instructions for electrical connec-

tions.

• The electrical mains terminal is live.

• Make electrical mains terminal free of voltage.

• Install correctly to give anti-shock protection.

• Loose and incorrect mains plug and socket connections can make the terminal become

too hot.

• A qualified electrician must install the clamping connections correctly.

• Use a strain relief clamp on cable.

• Use the correct mains connection cable and replace the damaged mains cable with prop-

er special cable. Speak your local Service Force Centre.

• The appliance must have the electrical installation which lets you disconnect the appli-

ance from the mains at all poles with a contact opening width of minimum 3 millime-

tres.

• If the fixing bracket is near to the terminal block, always make sure the connection cable

does not come in contact with the edge of the bracket.

• You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses

removed from the holder), ground leakage trips and contactors.

Manufacturer is not responsible for any injury to persons and pets or damage to prop-

erty caused by failure to obey these requirements.

Electrical connection

• Ground the appliance according to safety precautions.

• Make sure that the rated voltage and type of power on the rating plate agree with the

voltage and the power of the local power supply.

• This appliance is supplied with a mains cable. It has to be supplied with a correct plug,

able to support the load marked on the rating plate. The plug has to be fitted in a correct

socket.

• Any electrical component must be installed or replaced by the Service Force Centre tech-

nician or qualified service personnel.

• Always use a correctly installed shockproof socket.

18 Installation

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Comentarios a estos manuales

Sin comentarios

AEG HK312000H Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Placas AEG HK312000H