AEG HG654820UM Manual de usuario Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 20
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
6.5 Cleaning the flame
spreader
You can wash the flame
spreaders in a dishwasher.
WARNING!
Let the flame spreaders cool
down before you clean
them.
Light stains:
Wash the flame spreader with warm
water and soap and dry it with a soft
cloth.
Medium stains:
Use the dishwasher. Place the flame
spreader on the bottom rack in a flat
position, with the top side up.
Heavy stains:
Clean the flame spreader with warm
water and soap, then wash it in the
dishwasher. If the stain is still present
wash the top of the flame spreader with
a grill cleaner and run through the
dishwasher again.
Use a toothpick to clean the holes of the
flame spreader.
6.6 Cleaning the spark plug
This feature is obtained through a
ceramic ignition candle with a metal
electrode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
6.7 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the
conditions of the gas supply pipe and
the pressure adjuster, if fitted.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem Possible cause Remedy
There is no spark when you
try to activate the spark gen-
erator.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply.
The fuse is released. Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Flame spreader is placed in-
correctly.
Place the flame spreader
correctly.
The flame extinguishes im-
mediately after ignition.
Thermocouple is not heated
up sufficiently.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.
www.aeg.com10
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentarios a estos manuales

Sin comentarios