AEG HG654320UM Manual de usuario descargar pdf (Pagina 9)

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-pass screw position.

1 The by-pass screw

– If you change from natural gas 20 mbar to liquid gas, fully tighten the adjustment

screw in.

– If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw ap-

proximately 1/4 of a turn.

WARNING!

Make sure the flame does not go out when you quickly turn the knob from the maximum

position to the minimum position.

Electrical connection

• The electrical work necessary to install the appliance must be done by a qualified electri-

cian or competent person, according to the current regulations.

• The appliance must be earthed.

• Always use a correctly installed shockproof socket.

• Make sure that there is access to the mains plug after the installation.

• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.

• The appliance must not be connected with an extension cable, an adapter or a multiple

socket. There is a risk of fire. Make sure that the ground connection complies with the

standards and regulations force.

• The power cable must not touch any hot parts.

• The electrical installation must have an isolation device which lets you disconnect the

appliance from the mains at all poles. The isolation device must have a contact opening

width of minimum 3 mm.

• You must have the correct isolation devices: line protecting cut-outs, fuses (screw type

fuses removed from the holder), earth leakage trips and contactors.

• The connection cable parts must not be heated to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must comply with the latest I.E.E. Regulations and local

Electricity Board regulations. For your own safety the installation must be done by a quali-

Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

AEG HG654320UM Manual de usuario Pagina 9