AEG 65300K-MNAB1 Manual de usuario descargar pdf (Pagina 34)

Installing and Connecting Up

The separation between the hob and the extractor hood must be at

least as large as that given in the extractor hood installation instruc-

tions.

• For protection against moisture, all cut surfaces are to be sealed with

a suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits must

be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action springs

must be bonded in place.

• Ensure that the seal is correctly seated in the frame and that it is

seated against the work surface without leaving any gaps. Additional

silicon sealant must not be applied, this will make removal more diffi-

cult in the event of the need for service.

• To remove the hob, it must be pressed out from below.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

AEG 65300K-MNAB1 Manual de usuario Pagina 34