AEG F55010M0 Manual de usuario

FAVORIT((18VHU0DQXDO

Press the on/off button. The appliance is not in setting mode when:– Only one programme indicator light comes on.– The display shows the duration of a

Water hardnessWater hardness ad-justmentGerman degrees(°dH)French degrees(TH°)mmol/l Clarke de-greesmanually elec-tronical-ly4- 10 7- 18 0,7 - 1,8 5-

USE OF DISHWASHER SALTHow to fill the salt container1. Turn the cap counterclockwise and openthe salt container.2. Fill the salt container with 1 litr

5. Close the detergent dispenser. Press the lid until it locks into position.Different brands of detergent dissolve in different times. Some detergent

To deactivate the multitab function and use separately detergent, salt and rinse aid1. Activate the appliance.2. Make sure that the appliance is in se

The rows of prongs in the lower basket can be flatto load pots, pans and bowls.The cutlery basketPut the forks and spoons with the handles down.Put th

Upper basketThe upper basket is for plates (maximum 24 cm indiameter), saucers, salad bowls, cups, glasses, potsand lids. Arrange the items to let wat

1. Pull the basket out until it stops.2. Carefully lift the two sides until themechanism is engaged and the basket isstable.Do these steps to move the

Consumption valuesProgramme1)Energy (kWh) Water (litre)1,1-1,8 12-231,5-1,7 16-180,9 91,0-1,1 13-150,8-0,9 14-151) The display shows the programme tim

The opening of the appliance door interrupts the countdown. When you close the door, thecountdown continues from the point of interruption.You can sel

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

Remove the items from the baskets• Let the dishes become cold before you remove them from the appliance. Hot dishes canbe easily damaged.• First remov

3. Remove the flat filter (C) from the bottomof the appliance.4. Fully clean the filters with water.5. Put the flat filter (C) to its initial position

Malfunction Possible cause Possible solutionThe connection of the waterinlet hose is not correct.Make sure that the connectionis correct.The water inl

Problem Possible cause Possible solutionThe spray arms could not turnfreely because of incorrect ar-rangement of the load.Make sure that an incorrect

– The display shows the current set.Rinse aid dispenser deactivatedRinse aid dispenser activated6. Press function button B again.– The display shows t

WARNING!To discard the appliance, follow the procedure:• Pull the mains plug out of the socket.• Cut off the mains cable and mains plug and discard th

3. Lift the worktop and move it from thefront slots (3).4. Use the adjustable feet to adjust the levelof the appliance.5. Install the appliance under

27

www.aeg.com/shop"

CONTENTS4 Safety information7 Product description8 Control panel10 Use of the appliance10 Setting the water softener12 Use of dishwasher salt12 Use of

SAFETY INFORMATIONBefore the installation and use, read this manual carefully:• For your safety and the safety of your property.• To help the environ

• Fill the appliance with salt before you start a washing programme. Remaining salt in theappliance can cause corrosion or make a hole in the bottom o

• The water inlet hose has a safety valve and a double sheath with an inner mains cable.There is pressure in the water inlet hose only when the water

– Cut off the mains cable and discard it.– Remove the door catch. This prevents children or pets to be closed in the appliance.There is a risk of suff

9 Upper spray arm10 WorktopCONTROL PANEL1 26ABCDE23541 On/off button2 Programme selection buttons3 Delay start button4 Indicator lights5 Display6 Func

Indicator lightsRinse aid 1)It comes on when it is necessary to fill the rinse aid container. Refer to'Use of detergent and rinse aid'.1) Wh