Aeg L89499FL Manual de usuario

L 88409 FL2 EN User manual

• The percentage of the detergent quantity.The symbols shows the quantity of deter-gent to use for the laundry in the drum.When you press the Start/Pa

4.8 Stain-Prewash button 8Press button 8 to add the stain and/ora prewash phase to a programme.Press the button again and again to acti-vate one or tw

5. PROGRAMMESProgrammeTemperature rangeType of load and soilMaximum load, Maximum spinCottons95°C - ColdWhite cotton and coloured cotton. Normal soila

ProgrammeTemperature rangeType of load and soilMaximum load, Maximum spin Cottons Eco5)60 °C - 40 °CWhite cotton and colour-fast cotton. Normalsoil.10

ProgrammeStains/PrewashExtra RinseTime SaveDelay StartRinse Outdoor 20 Min. - 3 kg Super Eco Cotto

Programmes Load(Kg)Energyconsump-tion (kWh)Water con-sumption(litre)Approxi-mate pro-grammeduration(minutes)Remain-ing mois-ture (%)1)Synthetics 40°C4

3.The indicator of button 4 flasheswith red colour.4.The display shows the default tem-perature and spin and the empty in-dicator bars of the availabl

8.3 Filling the detergent and additivesThe detergent compartment for the prewash phase and thesoak programme.Add the detergent for prewash and soak be

3.To use powder detergent, turn theflap up.4.To use liquid detergent, turn theflap down.With the flap in the positionDOWN:– Do not use gelatinous or t

The appliance adjust auto-matically the cycle time to thelaundry you have put in thedrum to have perfect washingresults in the minimum neces-sary time

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY

2.Press the Start/Pause button 4 .The appliance drain the water andspin.3.When the programme is completedand the door lock symbol goes off,you can ope

10. CARE AND CLEANINGWARNING!Disconnect the appliance from the mainssupply before you clean it.10.1 DescalingThe water we use contains limescale. If i

10.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.

To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the

129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven

Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra

Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no

Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma

After the check, activate the appliance.The programme continues from thepoint of interruption.If the problem occurs again, contact theservice centre.I

ENGLISH 29

1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i

30www.aeg.com

ENGLISH 31

www.aeg.com/shop132912250-A-172013

• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.

mains plug, use a 13 amp ASTA (BS1362) fuse.•This appliance complies with theE.E.C. Directives.Water connection• Make sure not to cause damage to thew

3. PRODUCT DESCRIPTION1 2 3 8956741011121Worktop2Detergent dispenser3Control panel4Door handle5Rating plate6Drain pump7Feet for the appliance level8Wa

4. CONTROL PANELTemp.SpinStart/PauseDelayStartTimeSaveExtraRinseStains/Prewash1 2 345678910CottonsExtra SilentSyntheticsEasy IronDelicatesDuvetAnti-Al

4.3 Display 3A HK JC D E F GBM LIThe display shows:AThe temperature of the set programmeCold waterBThe spin speed of the set programmeNo Spin symbol1)

FYou cannot open the appliance door when the symbolis on.You can open the door only when the symbol goes off.If the programme is completed but the sym